A genie garage door opener which has only 3 terminals on its motor head will use.
Genie garage door press and hold button.
This sets the in car transmitter to be your garage door openers make transmitter but you are not done.
Press and hold the wall console button until the garage door is completey closed.
For genie intellig trilog series built from 2009 until july 8 20011 intellicode iii see serial on front.
Press the learn button on the garage door motor.
Within 30 seconds return to the vehicle and press and hold the homelink button you trained in step 5 for two seconds.
Release the prgm or learn button and the larger led light will begin to blink.
Hold your transmitter up near the selected button pressing both the garage door remote and the selected in car transmitter button simultaneously.
Find the learn or program pgrm button on your genie garage door opener.
Hold down on the buttons until the in car red light flashes rapidly.
The blue light should stay lit.
After preparing the remote to receive a yellow learn button unit on the garage door opener.
First 2 digits year next 3 digits day of the year press and hold down on the square button of your genie of fairview system until the round blue led comes on then release the button.
Genie garage door opener systems accessories and installations are well known and trusted by consumers.
Repeat the press hold and release sequence up to three times.
If an operational problem exists and the garage door opener will not close the opener can be forced to close.
Door starts down then stops before it is closed.
Check for interference from adjacent photo eye sensors of any brand.
If the blue light stays on go to instructions for intellicode iii below.
Explore our product and support offerings today.
On the remote press and release the pre set button or the button you just programmed once every 2 seconds until the garage door opener operates.
Press the homelink button that you would like to operate your genie garage door opener 3 times hold each press for one.
Hold down the learn or program button until the small led turns on.
Let it run until it stops.
The long purple led button will start to blink.